What They'd Do

- Write new eval tasks where a model designs one passive on-chip component to a spec (e.g., a spiral inductor with a target inductance, quality factor and area), then simulates it and iterates.
- For each task, write the spec, a reference design that meets it and an automatic check that re-simulates the submitted layout and compares the results with the spec.
- Start with a pilot of 5 tasks, then iterate with us before scaling.

Must have

- Hands-on RF IC design, including laying out passives (e.g., spiral inductors, transformers and baluns, transmission lines, coupled resonators, quadrature hybrids).
- Has run EM simulations on their own layouts and can read the results (e.g., S-parameters, inductance and quality factor).
- Works with GDS layouts and S-parameter files.




- Enough Python to script simulations and write the checks.

Nice to have

- Experience with IHP SG13G2 or another open PDK (our test chip is a 24 GHz radar receiver front end on SG13G2).
- The open-source tools we use: KLayout, Palace, openEMS, ngspice, scikit-rf. We can share our container (IIC-OSIC-TOOLS).
- Commercial EM solvers (e.g., Cadence EMX or Ansys HFSS).
- SPICE simulation of RF blocks (e.g., a low noise amplifier), which we'd like to cover later.

Location: Europe, Canada, US Final rate depends on qualifications, expertise, experience, and location

📌 Analogue RF IC Designer for EM Simulation Tasks (España)
🏢 Braintrust
📍 España